AT28BV64-25SI belongs to the category of non-volatile memory devices.
It is primarily used for storing and retrieving digital information in electronic systems.
The AT28BV64-25SI is available in a Small-Outline Integrated Circuit (SOIC) package.
The essence of AT28BV64-25SI lies in its ability to provide non-volatile memory storage with high capacity and fast access times.
The device is typically packaged in reels or tubes, with each containing a specific quantity of AT28BV64-25SI chips.
The AT28BV64-25SI has a total of 28 pins, which are assigned specific functions. The pin configuration is as follows:
The AT28BV64-25SI utilizes a combination of electronic circuits and memory cells to store and retrieve data. It employs a parallel interface, allowing for simultaneous transfer of multiple bits of data. The device uses address inputs to select specific memory locations and control signals to enable read or write operations.
The AT28BV64-25SI finds applications in various electronic systems, including but not limited to: 1. Embedded systems 2. Consumer electronics 3. Industrial automation 4. Automotive electronics 5. Medical devices
In embedded systems, it can be used for firmware storage, configuration data, or program code storage. In consumer electronics, it may serve as non-volatile memory for digital cameras, set-top boxes, or gaming consoles. Industrial automation systems can utilize it for storing critical parameters or log data. Automotive electronics may employ it for storing calibration data or firmware updates. Medical devices can benefit from its non-volatile memory capabilities for storing patient data or device configurations.
Sure! Here are 10 common questions and answers related to the application of AT28BV64-25SI in technical solutions:
Q: What is the AT28BV64-25SI? A: The AT28BV64-25SI is a 64K (8K x 8) EEPROM (Electrically Erasable Programmable Read-Only Memory) chip manufactured by Microchip Technology.
Q: What is the operating voltage range for the AT28BV64-25SI? A: The AT28BV64-25SI operates within a voltage range of 2.7V to 3.6V.
Q: What is the maximum clock frequency supported by the AT28BV64-25SI? A: The AT28BV64-25SI supports a maximum clock frequency of 25 MHz.
Q: Can the AT28BV64-25SI be used for code storage in microcontroller-based systems? A: Yes, the AT28BV64-25SI can be used for code storage in microcontroller-based systems as it provides non-volatile memory storage.
Q: How many write cycles can the AT28BV64-25SI endure? A: The AT28BV64-25SI can endure a minimum of 10,000 write cycles.
Q: Does the AT28BV64-25SI support byte-level read and write operations? A: Yes, the AT28BV64-25SI supports byte-level read and write operations, allowing for efficient data manipulation.
Q: Is the AT28BV64-25SI compatible with standard EEPROM interfaces? A: Yes, the AT28BV64-25SI is compatible with standard EEPROM interfaces such as SPI (Serial Peripheral Interface) and I2C (Inter-Integrated Circuit).
Q: Can the AT28BV64-25SI be used in automotive applications? A: Yes, the AT28BV64-25SI is suitable for automotive applications as it meets the necessary temperature and reliability requirements.
Q: What is the typical access time of the AT28BV64-25SI? A: The typical access time of the AT28BV64-25SI is 90 ns, allowing for fast data retrieval.
Q: Does the AT28BV64-25SI support software and hardware write protection? A: Yes, the AT28BV64-25SI supports both software and hardware write protection mechanisms to prevent accidental data modification.
Please note that these answers are based on general knowledge about the AT28BV64-25SI and may vary depending on specific application requirements.