M25P80-VMP6G

Product Overview

Category

M25P80-VMP6G belongs to the category of Serial Flash Memory.

Use

It is primarily used for storing and retrieving digital data in electronic devices.

Characteristics

• Non-volatile memory: Retains data even when power is turned off.
• High storage capacity: Can store up to 8 megabits (1 megabyte) of data.
• Serial interface: Uses a serial peripheral interface (SPI) for communication.
• Fast read and write operations: Offers high-speed data transfer.
• Low power consumption: Optimized for energy efficiency.

Package

The M25P80-VMP6G comes in a small form factor package, suitable for integration into various electronic devices.

Essence

The essence of M25P80-VMP6G lies in its ability to provide reliable and high-capacity non-volatile memory storage for electronic devices.

Packaging/Quantity

The product is typically packaged in reels or trays, with a quantity of 2500 units per reel/tray.

Specifications

• Memory Size: 8 megabits (1 megabyte)
• Interface: Serial Peripheral Interface (SPI)
• Operating Voltage: 2.7V - 3.6V
• Operating Temperature Range: -40°C to +85°C
• Data Retention: Up to 20 years
• Erase/Program Cycle Endurance: 100,000 cycles

Detailed Pin Configuration

The M25P80-VMP6G has the following pin configuration:

1. Chip Select (/CS)
2. Serial Clock (SCLK)
3. Serial Data Input (SI)
4. Serial Data Output (SO)
5. Write Protect (/WP)
6. Hold (/HOLD)
7. Ground (GND)
8. Power Supply (VCC)

Functional Features

• High-speed read and write operations
• Sector erase and byte/page program operations
• Software and hardware write protection options
• Deep power-down mode for low-power consumption
• Status register for monitoring device status
• Advanced security features for data protection

Advantages and Disadvantages

Advantages

• Large storage capacity
• Fast data transfer rate
• Low power consumption
• Compact form factor
• High endurance

Disadvantages

• Relatively higher cost compared to lower-capacity flash memory options
• Limited compatibility with devices that do not support SPI interface

Working Principles

The M25P80-VMP6G utilizes the Serial Peripheral Interface (SPI) protocol to communicate with the host device. It stores data in non-volatile memory cells, which retain information even when power is disconnected. The device can be accessed by sending commands through the SPI interface, allowing for efficient reading and writing of data.

Detailed Application Field Plans

The M25P80-VMP6G is widely used in various electronic devices, including but not limited to: - Consumer electronics (e.g., smartphones, tablets, digital cameras) - Automotive systems (e.g., infotainment systems, instrument clusters) - Industrial equipment (e.g., control systems, measurement devices) - Communication devices (e.g., routers, modems)

Detailed and Complete Alternative Models

1. M25P16-VMP6G: 16 megabits (2 megabytes) memory size
2. M25P32-VMP6G: 32 megabits (4 megabytes) memory size
3. M25P64-VMP6G: 64 megabits (8 megabytes) memory size

These alternative models offer different memory capacities to suit specific application requirements.

Word count: 490 words